C-G2Q FUEL DISPENSER

C-G2Q FUEL DISPENSER

FlowMeter Type: Optional

Accuracy : ±0.2%

Pressure Loss (kg/cm): Under 0.25

Motor Voltage(V): 110V/220V/380V,50Hz/60Hz

Capacity(hp): 1HP(0.75kw)

Input Voltage: 110V/220V/380V,50Hz/60Hz

Nozzle : Auto Shut-off Nozzle

Environmental Condition : -40~~+55degree

Control Type : Solenold Vale Control Type

Preset Function :Provided(Small LCDIndicator)

Display(Counter) :Type LCD and Bright Backlight

Digit of Volume : 0~~999,999(6 Digits),Decimal point can be changed

Digit of Amount : 0~~999,999(6 Digits),Decimal point can be changed

Digit of Unit price : 0~~9999(4 Digits),Decimal point can be changed

Digit of Total Range : 0~~99,999,999,99

Optional Display Type: LCD and Bright Backlight

Digit of Volume :0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Amount: 0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Unit price: 0~~999999(6 Digits),Decimal point can be changed

Digit of Total Range: 0~~99,999,999,99

Totalizer:1~~9,999,999

Hose:4.5m

Weight :215kg

Dimension(L×W×H): 1100*525*2170(mm)

Dimension(L×W×H)Of Qty of Container: 40ft: 44 20ft: 22

be installed in oil; in some regions and mount areas adopts high bracket tank, to refuel through oil gravity. Under these two situations the inlet oil pressure of fuel dispenser is larger than atmospheric pressure. The latter model adopts volume pump --- often gear pump or vane pump, installing insi fuel dispenser de of fuel dispenser together with motor. A certain vacuum pressure occurs at the inlet of fuel dispenser when fueling. Fuel dispenser mounted submersible pump, its pump being inside of tank with low noise, has large room to facilitate design many nozzles. The negative pressure fuel dispenser, however, has the benefit of convenient maintenance and low price of whole system. At recent, as negative pressure one prevails in market, the article mainly introduce this kind of fuel dispenser. Negative pressure fuel dispenser normally selects a ration cubage pump. In order to ensure adjusting flow rate there is a bypass valve connected with pump in juxtaposition. When refueling fuel dispenser’s discharge capacity is controlled by the return volume of bypass valve that, of course, ensure the hydraulic system security of fuel dispenser. This kind of bypass valve generally is overflow valve that is closed down while fuel dispenser dot work, and always open as fuelling. The return volume of overflow valve is changed by fuel dispenser’s flowage. Pump is a key component. Its p fuel dispenser erformance is measured through the following aspects: suction capacity, reliability, noise and stability. Of date, some manufacturer put pump and oil-air separator into a common frame, but some install these elements respectively. Some people in circle call pump and oil-air as pump source. Pump’s performance only relate to its structure design and manufacturing level, not the connection of components. The handbook, therefore, introduce by the category of pump, not by the connection of oil-air separator. Vance pump It is also called rolling broad pump. Tanks to less weigh than gear pump and column plug pump, high pollute-resistant, simple structur fuel dispenser

　　 It is enclosed as follows:　　 bit 1 = Satallite master nozzle　　 bit 2 = Satallite slave nozzle No. 1　　 bit 3 = Satallite slave nozzle No. 2　　 bit 4 = Satallite slave nozzle No. 3　　 bit 5 = 2 speed standard flow nozzle　　 fuel dispenser bit 6 = 2 speed high flow nozzle　　 bit 7 = Multi product through one nozzle (i.e. blender)　　 Note these bits are valid only when the corresponding　　 nozzle type corresponds to one of the model types listed　　 above.　　 If the nozzle does not correspond to one of the models　　 listed or if no physical nozzle is removed this Data_Id　　 has the value 00.　　 Multi_Nozzle_State　　 44 Bin8 R (1-9) O　　 (2CH) These bits correspond to the physical nozzle state　　 0 = Nozzle not removed　　 1 = Nozzle removed　　 Note this Data Id will reflect the physical state of any　　 nozzle not just the types listed in Data_Id 43.　　 Any changes in the Multi_Nozzle State must result in　　 unsolicited FP Multi Nozzle_Status_Message (Data_Id　　 101)　　 45 fuel dispenser Bin8 R (6-9) O　　 Multi_Nozzle_Status_Message　　 (2DH)　　 These bits correspond to the nozzle definitions in Data_Id W (6-9)　　 44.　　 0 = Flow disabled through respective nozzle　　 1 = Flow enabled through respective nozzle　　 Where the dispenser does not allow a flow from the　　 requested nozzle to be controlled the write is rejected　　 with a Data_ACK = 2 (Not Writable).　　 The default value is despenser specific. Some despense fuel dispenser

l and Poland all needed to restructure their debt. Herrhausen was deeply involved in all three areas as adviser to Chancellor Helmut Kohl, as the arranger of the Soviet Union s last big credit and as the spearhead of an initiative to link debt forgiveness with a country s readiness to undergo po fuel dispenser litical and economic reform. Rowohlt-Berlin Verlag; 320 pages; �9.90 At the same time, he was trying to turn Deutsche Bank upside down. In Buy it at fact he wanted to reform the entire international banking system. For Amazon.de Herrhausen was a rare creature, a man of great ability who was dedicated to getting things done. “The world,�he said in his best remembered speech, “is not a debating club.� Herrhausen tried desperately to reconcile his role with the philosophical writings of Karl Popper, Friedrich Hayek, Wolfgang Stegmüller and even Confucius, whose writings he kept in his office. He was unashamedly patriotic and unashamedly elitist, but with an elitism he hoped was dedicated to serving the public good. That made him unpopular with the old guard in his own bank who never really accepted him. Herrhau fuel dispenser sen had joined as a board member in 1970 from the Ruhr power utility, Vereinigte Elektrizitaetswerke Westfalen (VEW). To many he was the embodiment of Deutschland AG, the matrix of power that links banks and industrial companies. He sat on the supervisory boards of Daimler-Benz, a huge industrial group, and Continental, a tyre company. He led an initiative to revive the Ruhr, started a private university and began a foundation to help the disadvantaged become more self-sufficient. He also made mistakes, such as helping his friend Edzard Reuter, head of Daimler- Benz, to merge the company with Messerschmidt-Bölkow-Blohm, maker of defenc fuel dispenser